|
|
Your lettering arrives in a three-layer piece:
TOP LAYER: The clear transfer tape
MIDDLE LAYER: The actual lettering
BOTTOM LAYER: The hard paper that the cut lettering is on
Step 1: Peel
Use a wooden spoon to rub the TOP LAYER of your phrase, making sure you rub corners and periods, etc. This is to make sure the letters and designs stick to the application tape. You don't need to rub the whole top, just where the lettering is. Peel off the BOTTOM LAYER or stiff backing paper at a 45 degree angle. Slowly peel off the BOTTOM LAYER.
Step 2: Stick
Place just the corners of the application tape to the wall; make sure your saying is level and centered. Once again, firmly rub across the TOP LAYER, over just the lettering, with the wooden spoon.
Step 3: Peel Away Transfer Paper
Slowly pull the TOP LAYER of transfer paper away from the wall at a 45 degree angle. I usually begin from the top right corner going down and to the left. Be patient and your lettering will remain on the wall. Depending on your surface, you may have to roll the transfer tape off of the lettering, while holding the edge of the LETTERING to the wall with your finger.
Step 4: Clean wall
Clean off your wall to get rid of any finger prints. Be sure your rag is not too wet. Just dab the letters, don’t wipe or you might peel off some of the letters. |
|
 |
|
|
